EGO CH7000 turbo charger: LED 3 is flashing red. What does it mean?
Short answer: On the CH7000E turbo charger, LED 3 flashing red (or all the LEDs off) means the battery pack or charger is malfunctioning, or the connection between them is poor. EGO's fix is to reseat the pack, try a different pack, then reset the charger.
Applies to: EGO CH7000E 56V turbo charger (checked against EGO's CH7000E manual). Other EGO chargers use different lights.
What EGO says
"If the charger detects a problem, LED Indicator 3 will flash red or all the LEDs will turn off."
Source: EGO CH7000E Operator's Manual, "Defective battery pack or charger" (p. 7) and Troubleshooting (p. 9). Official PDF
Steps EGO recommends
- Remove and reinsert the battery pack in the charger.
- Try a different battery pack. If the other pack charges normally, the first pack is the problem.
- Reset the charger. If a different pack also reads defective, unplug the charger, wait until the flashing LED 3 goes out, then plug it back in.
If the steps point to a bad battery or charger
As an Amazon Associate I earn from qualifying purchases.
Only replace a part after the steps above show which one is defective. These are EGO's own (OEM) parts.
- EGO POWER+ 56V 5.0Ah Battery (BA2800T): EGO's own 5.0Ah battery, listed as compatible in the CH7000E manual.
- EGO POWER+ 700W Turbo Charger (CH7000): EGO's own charger, the same model this page covers.
When to stop and contact support
EGO says that if no charger LEDs briefly shine green together for the self-check when you plug it in, or LED 3 still shows defective, the charger may be defective. Contact EGO Customer Service (1-855-EGO-5656 in the US).
Related questions
Checked against EGO's official manual: November 18, 2026.
This is a convenience reference based on the manufacturer's official manual. Always follow the official manual and safety instructions for your specific model. Tool Decoder is not affiliated with or endorsed by EGO or Chervon. EGO POWER+ is a trademark of its owner. Incorrect procedures can damage equipment or create safety hazards.