Tool Decoder

What the lights and error codes on your tools mean, from the manufacturer's manual.

Husqvarna Automower charging station is solid blue. What does it mean?

Short answer: A solid blue light on the charging station means the boundary wire signal is weak. Husqvarna says that if the mower is working normally, nothing needs to be done right away, but fixing the weak signal can prevent problems later.

Applies to: Husqvarna Automower installations with a boundary wire. A flashing blue light means something different.

What Husqvarna says

"A solid blue light on your Automower® charging station indicates that the boundary wire signal is weak."

Source: Husqvarna Support, "What does a solid blue light on the Automower® charging station mean?" (KA-01721). Official page

Steps Husqvarna recommends

  1. Check the wire length. Husqvarna's maximum recommended boundary wire length is 800 m (2,600 ft).
  2. Look for damage. Check the boundary wire for breaks or damage, for example from gardening, and replace damaged sections with new loop wire.
  3. Check the connections at the charging station. The wires should be properly attached, and the connectors and pins shouldn't be damaged, corroded or worn.

If you need to repair the wire

As an Amazon Associate I earn from qualifying purchases.

Husqvarna says to replace a damaged section with new loop wire. These are Husqvarna's own parts.

When to stop and contact support

If the light stays solid blue after these checks, Husqvarna says to contact your local Husqvarna dealer.

Related questions

Checked against Husqvarna's official support page: November 18, 2026.

This is a convenience reference based on the manufacturer's official support information. Always follow the official manual and safety instructions for your specific model. Tool Decoder is not affiliated with or endorsed by Husqvarna. Automower® is a registered trademark of Husqvarna AB. Incorrect procedures can damage equipment or create safety hazards.